Concrete Contractor in Cedar Park, TX - Driveways and Patios Built on a Solid Base
What Cedar Park driveways and patios need underneath
Cedar Park is mostly neighborhoods of single-family houses, with shops and offices along the main roads, and most of our calls there are for driveways, back patios, walkways and garage floors. A lot of those houses went up in subdivisions over the last few decades, so we're often replacing a first driveway that has settled or cracked, or adding the patio the builder left out. We're a concrete contractor based in Round Rock, TX, and Cedar Park is a short drive west, with Brushy Creek in between and Leander just north.
The ground isn't the same from yard to yard here. Some lots have rock close to the surface, others have softer dirt and plenty of them slope, so I decide how deep to dig and how the slab will drain while I'm standing on the lot, not from a photo.
What concrete runs into in Cedar Park
Hot pour days
Summer heat dries the top of a slab too fast, leaving a weak, dusty surface that chips later. We pour early in the morning so the crew finishes before the heat sets in.
Water headed for the house
Hard rain runs fast across a yard, and a slab that tilts toward the house sends that water at your foundation. We check where the water runs before we set any forms.
Bases that were only raked
A slab poured on dirt that was only raked level settles when that dirt does, and the cracks follow. We dig out and pack the subgrade, the ground the slab sits on, first.
Older slabs cracking anywhere
Older slabs often crack at random because the control joints, cuts that pick where cracks go, came late or never. We cut ours on time, so a crack has a line to follow.
Should I repair or replace my Cedar Park driveway?
Repair it if the slab is still level and the cracks are thin, because sealing them keeps water out of the base and buys the slab time. Replace it when sections have sunk, tilted toward the house or hold standing water, since that means the base under it has failed and anything patched on top will crack again. I'll tell you which one you've got once I've seen it.
When we replace, most of the effort goes into the base, because that's what decides whether the new slab cracks like the old one, even though nobody sees it after the pour. If the budget's tight, I'd keep a plain broom finish, the light brushed texture that gives shoes and tires grip, before I'd thin out the base. With the base right, decorative concrete such as color or a pattern is an option on top.
Concrete services in Cedar Park
- Concrete driveway building in Cedar Park, TX
- Concrete patio construction in Cedar Park, TX
- Stamped concrete services in Cedar Park, TX
- Concrete sidewalk building in Cedar Park, TX
- Garage floor concrete in Cedar Park, TX
- Decorative concrete in Cedar Park, TX
- Concrete retaining walls in Cedar Park, TX
- Concrete floor installation in Cedar Park, TX
- Concrete pool decks in Cedar Park, TX
- Concrete steps construction in Cedar Park, TX
- Slab foundation building in Cedar Park, TX
- Foundation installation in Cedar Park, TX
- Concrete parking lot building in Cedar Park, TX
- Concrete footings in Cedar Park, TX
- Foundation raising in Cedar Park, TX
- Concrete cutting in Cedar Park, TX
Cedar Park concrete questions
How much does a new concrete driveway cost in Cedar Park?
Your price depends on the size of the slab, how much digging and base work the lot needs and the finish you choose, so I give you a number after I've looked at the job on site. Tearing out an old slab, a spot the truck can't reach and stamped or colored finishes raise it, while a simple shape with a broom finish keeps it down. Rebar, the steel inside that holds the slab together, adds to it too, and it's not where I'd save money.
Do I need a permit to pour a concrete driveway or patio in Cedar Park?
Ask the city's Building Permits & Inspections office, because it issues residential construction permits in Cedar Park and decides what your job needs. Before we set a date, we check which office covers your address, and if a permit is needed, we handle the application and keep it moving.
Do contractors have to register with the City of Cedar Park?
Yes, the city is putting in a new requirement that every contractor, whether they've worked there for years or are new, registers with it. It's part of how the city handles permits, it costs nothing and it links to the city's online permitting system.
What building codes does Cedar Park use?
Cedar Park builds to the International Building and Residential Codes, the related fire, plumbing, mechanical, energy and pool codes, and the National Electrical Code. Each one comes with the city's own local amendments, which are changes the city made to the model code text and keeps in its code of ordinances.
How do I pull a residential permit myself in Cedar Park?
You'll need to sign the city's Homeowner's Affidavit, and the city's residential permits page has a submittal checklist for remodels and additions plus a guideline packet to start from. Applications go through the city's MGO Connect portal, where you set up an account, apply, pay, check status and request inspections. The permits office answers at 512-401-5100, Monday through Friday, 8 am to 5 pm.
How long will I be without my driveway after a new pour in Cedar Park?
You're off it for the tear-out, the pour and the curing, and curing, the wait while the concrete hardens and gains strength, is the longest part. You'll walk on it well before you can park on it, and how long each takes turns on the weather and the slab. At the estimate I lay out each step, from tear-out to the first day you drive on it, so you can plan around it.
Nearby cities, or give us a call
Choose your city from the list, or call (512) 276-6396 if yours isn't there, since we work in many cities around Round Rock.
Tell us about your Cedar Park slab
Send your address and the job, and we'll reply within one business day to set a time for me to come out. The estimate's free, with no obligation.